Featured product - USB-I2C/SPI/GPIO Adapter U2C-12
| Accessories |
|---|
| I2C Cable for U2C-12 with Clips and Crocodile |
| Documentation |
|---|
USB-I2C/SPI/GPIO API 0.2.0 |
USB-I2C/SPI/GPIO API 0.2.0 |
Online API Documentation |
|
Schematics |
|
FAQ |
| Related products |
|---|
| USB-IO Interface Adapter - GPIO-24 |
U2C-12 USB-I2C/SPI/GPIO Interface Adapter Users Manual
3.7.2. U2C_SpiGetConfig()
U2C_RESULT U2C_SpiSetConfigEx( HANDLE hDevice, DWORD Config );
The U2C_SpiSetConfigEx() function enables/disables and configures SPI interface.
Parameters:
- hDevice
Handle to the U2C-12 device.
- Config
SPI configuration bits:
- Bit 0: CPOL bit
- Clock polarity. Determines the CLK line idle state:
- 0 corresponds to idle low
- 1 corresponds to idle high
- Bit 1: CPHA bit
- Clock phase. Determines the valid data clock edge:
- 0 corresponds to valid data available on leading edge
- 1 corresponds to valid data available on trailing edge
- Bit 2: SPI Disable bit.
- 0 corresponds to SPI Enable. MOSI and CLK pins are outputs.
- 1 corresponds to SPI Disable. All SPI interface pins are inputs.
- Bits 3..31: Reserved Bits - should be 0.
- Bit 0: CPOL bit
- Clock polarity. Determines the CLK line idle state:
Return values:
U2C_SUCCESS
SPI bus was successfully configured.
U2C_HARDWARE_NOT_FOUND
U2C-12 device referenced by hDevice handle was not found.
