List of Figures

1.1. "Hardware" tab of the "System Properties" window
1.2. The "Driver Signing Options" window
1.3. The "License Agreement" window
1.4. Choosing the necessary application components
1.5. Choosing folder for Diolan U2C-12 installation
1.6. Choosing "Start Menu/Programs" folder for the Diolan U2C-12 shortcuts
1.7. "Found New Hardware Wizard" start window
1.8. "Found New Hardware Wizard" window for choosing searching options
1.9. The "Hardware installation" window appearance
1.10. The “Found New Hardware Wizard" completing window
2.1. The Control Panel main window
2.2. “I2C Configuration” dialog window
2.3. “Spi Bus Configuration” dialog window
2.4. "I2C Bridge Devices" Bar
2.5. “Open Device” dialog window
2.6. “Device not found” message
2.7. Information about serial number of U2C-12 adapter
2.8. Information about U2C-12 adapter software and firmware version
2.9. The I2C slave device addresses
2.10. “I2C Read” Bar
2.11. The result of the data reading from the I2C slave device
2.12. The "I2C Write" Bar
2.13. The result of data writing into the I2C slave device
2.14. "I2C Low Level" Bar
2.15. The START condition
2.16. The repeated START condition
2.17. The STOP condition
2.18. The information about the byte data reading with the "Ack" signal
2.19. "I2C Bus Level" Bar
2.20. Reading the SDA/SCL lines
2.21. The "SPI Bus" bar