Bootloader Commands And Responses
The following commands and responses are used to control and monitor the Bootloader module of a DLN-series adapter.
|DLN_BOOT_GET_MODE||Command is used to obtain current mode of your DLN-series adapter.|
|DLN_BOOT_ENTER_BOOTLOADER||Command is used in order to switch on the Bootloader mode.|
|DLN_BOOT_EXIT_BOOTLOADER||Command is used to switch off the Bootloader mode and continue in Application mode.|
|DLN_BOOT_GET_FLASH_DESC||Command is used to retrieve information about the device internal flash memory.|
|DLN_BOOT_WRITE_FLASH||Command is used to write new firmware into the device internal memory.|
|DLN_BOOT_READ_FLASH||Command is used to read the firmware, currently installed in the DLN-series adapter.|