DLN_I2C_SLAVE_SET_ADDRESS Command and Response

The DLN_I2C_SLAVE_SET_ADDRESS command is used to assign an I2C slave address to the specified I2C slave module of DLN-series adapter.

DLN_I2C_SLAVE_SET_ADDRESS Command

Go to response

 typedef struct
 {
    DLN_MSG_HEADER header;
    uint8_t port;
    uint8_t slaveAddressNumber;
    uint8_t address;
 } __PACKED_ATTR DLN_I2C_SLAVE_SET_ADDRESS_CMD;

Parameters:

header

Defines the DLN message header DLN_MSG_HEADER. The header contains several predefined fields and is used to identify and route messages. You must fill the following fields before sending the command:

Field	Description
size	The size of the message. Must be equal to the size of the DLN_I2C_SLAVE_SET_ADDRESS_CMD structure.
msgId	Identifies the message. For the DLN_I2C_SLAVE_SET_ADDRESS command it must be set to 0x0C05. You can use the DLN_MSG_ID_I2C_SLAVE_SET_ADDRESS constant.
echoCounter	Can be used to link a command to a response. The response will have the same echoCounter value. This field can be any numerical value from 0 to 0xFFFF (65536).
handle	A handle to the DLN-series adapter.

port

A number of the I2C slave port to be configured.

slaveAddressNumber

A number of the I2C slave address to be assigned.

address

An I2C slave address to be assigned to the specified I2C slave module of your DLN-series adapter.

DLN_I2C_SLAVE_SET_ADDRESS Response

Go to command

The adapter sends the DLN_I2C_SLAVE_SET_ADDRESS response after the DLN_I2C_SLAVE_SET_ADDRESS command execution. The result field informs a user whether the I2C slave address has been successfully assigned to the I2C slave module of your DLN-series adapter.

 typedef struct
 {
    DLN_MSG_HEADER header;
    DLN_RESULT result;
 } __PACKED_ATTR DLN_I2C_SLAVE_SET_ADDRESS_RSP;

Parameters:

header

Defines the DLN message header DLN_MSG_HEADER. The response header contains the following fields:

Field	Description
size	The size of the message. It is equal to the size of the DLN_I2C_SLAVE_SET_ADDRESS_RSP structure.
msgId	Contains the message id. For the DLN_I2C_SLAVE_SET_ADDRESS response it is set to 0x0C05. The DLN_MSG_ID_I2C_SLAVE_SET_ADDRESS constant can be used to check the message ID.
echoCounter	Links a command to a response. The echoCounter value is copied from the respective command header.
handle	A handle to the DLN-series adapter. You can use the handle field to determine the adapter that have sent the response.

result

Contains the result of the command execution. For DLN_I2C_SLAVE_SET_ADDRESS command DLN-series adapter can return the following result values:

Return Code	Description
DLN_RES_SUCCESS	The new I2C slave address has been successfully assigned.

DLN_I2C_SLAVE_SET_ADDRESS Command and Response