DLN_I2C_MASTER_PULLUP_IS_ENABLED Command and Response

The DLN_I2C_MASTER_PULLUP_IS_ENABLED command is used to retrieve information on whether the embedded pull-up resistor is currently activated for the specified I2C master port.

DLN_I2C_MASTER_PULLUP_IS_ENABLED Command

Go to response

Syntax

C/C++

 typedef struct
 {
    DLN_MSG_HEADER header;
    uint8_t port;
 } __PACKED_ATTR DLN_I2C_MASTER_PULLUP_IS_ENABLED_CMD;

Parameters:

header

Defines the DLN message header DLN_MSG_HEADER. The header contains several predefined fields and is used to identify and route messages. You must fill the following fields before sending the command:

Field	Description
size	The size of the message. Must be equal to the size of the DLN_I2C_MASTER_PULLUP_IS_ENABLED_CMD structure.
msgId	Identifies the message. For the DLN_I2C_MASTER_PULLUP_IS_ENABLED command it must be set to 0x030B. You can use the DLN_MSG_ID_I2C_MASTER_PULLUP_IS_ENABLED constant.
echoCounter	Can be used to link a command to a response. The response will have the same echoCounter value. This field can be any numerical value from 0 to 0xFFFF (65536).
handle	A handle to the DLN-series adapter.

port

An I2C master port to retrieve the information from.

DLN_I2C_MASTER_PULLUP_IS_ENABLED Response

Go to command

The adapter sends the DLN_I2C_MASTER_PULLUP_IS_ENABLED response after the DLN_I2C_MASTER_PULLUP_IS_ENABLED command execution. The response informs a user whether the embedded pull-up resistor is currently enabled for the specified I2C master port.

Syntax

C/C++

 typedef struct
 {
    DLN_MSG_HEADER header;
    DLN_RESULT result;
    uint8_t enabled;
 } __PACKED_ATTR DLN_I2C_MASTER_PULLUP_IS_ENABLED_RSP;

Parameters:

header

Defines the DLN message header DLN_MSG_HEADER. The response header contains the following fields:

Field	Description
size	The size of the message. It is equal to the size of the DLN_I2C_MASTER_PULLUP_IS_ENABLED_RSP structure.
msgId	Contains the message id. For the DLN_I2C_MASTER_PULLUP_IS_ENABLED response it is set to 0x030B. The DLN_MSG_ID_I2C_MASTER_PULLUP_IS_ENABLED constant can be used to check the message ID.
echoCounter	Links a command to a response. The echoCounter value is copied from the respective command header.
handle	A handle to the DLN-series adapter. You can use the handle field to determine the adapter that have sent the response.

result

Contains the result of the command execution. For DLN_I2C_MASTER_PULLUP_IS_ENABLED command DLN-series adapter can return the following result values:

Return Code	Description
DLN_RES_SUCCESS	The current setting for the embedded pull-up resistor for the specified I2C master porrt has been successfully retrieved.

port

Contains a number of the I2C master port.

enabled

Contains the current configuration of the I2C master port. The following values are available:

1	the embedded pull-up resistor is currently enabled for the specified I2C master port
0	the embedded pull-up resistor is currently disabled for the specified I2C master port

DLN_I2C_MASTER_PULLUP_IS_ENABLED Command and Response