DLN_GPIO_PIN_GET_CFG Command and Response

The DLN_GPIO_PIN_GET_CFG command is used to retrieve the current configuration settings of a single GPIO pin.

DLN_GPIO_PIN_GET_CFG Command

 typedef struct
 {
    DLN_MSG_HEADER header;
    uint16_t pin;
 } __PACKED_ATTR DLN_GPIO_PIN_GET_CFG_CMD;

Parameters:

header

Defines the DLN message header DLN_MSG_HEADER. The header contains several predefined fields and is used to identify and route messages. You must fill the following fields before sending the command:

Field	Description
size	The size of the message. Must be equal to the size of the DLN_GPIO_PIN_GET_CFG_CMD structure.
msgId	Identifies the message. For the DLN_GPIO_PIN_GET_CFG command it must be set to 0x010A. You can use the DLN_MSG_ID_GPIO_PIN_GET_CFG constant.
echoCounter	Can be used to link a command to a response. The response will have the same echoCounter value. This field can be any numerical value from 0 to 0xFFFF (65536).
handle	A handle to the DLN-series adapter.

pin

A pin to get the configuration from.

DLN_GPIO_PIN_GET_CFG Response

Go to command

The adapter sends the DLN_GPIO_PIN_GET_CFG response after the DLN_GPIO_PIN_GET_CFG command execution. The response will contain the retrieved device ID number.

 typedef struct
 {
    DLN_MSG_HEADER header;
    DLN_RESULT result;
    DLN_GPIO_PIN_CONFIG config;
 } __PACKED_ATTR DLN_GPIO_PIN_GET_CFG_RSP;

Parameters:

header

Defines the DLN message header DLN_MSG_HEADER. The response header contains the following fields:

Field	Description
size	The size of the message. It is equal to the size of the DLN_GPIO_PIN_GET_CFG_RSP structure.
msgId	Contains the message id. For the DLN_GPIO_PIN_GET_CFG response it is set to 0x010A. The DLN_MSG_ID_GPIO_PIN_GET_CFG constant can be used to check the message ID.
echoCounter	Links a command to a response. The echoCounter value is copied from the respective command header.
handle	A handle to the DLN-series adapter. You can use the handle field to determine the adapter that have sent the response.

result

Contains the result of the command execution. For DLN_GPIO_PIN_GET_CFG command DLN-series adapter can return the following result values:

Return Code	Description
DLN_RES_SUCCESS	Configuration was successfully retrieved.
DLN_RES_INVALID_HANDLE	Specified handle is not valid.
DLN_RES_CONNECTION_LOST	Connection to the DLN server was interrupted.
DLN_RES_INVALID_PIN_NUMBER	Specified pin number is not valid.

config

Contains the pin configuration DLN_GPIO_PIN_CONFIG.

DLN_GPIO_PIN_GET_CFG Command and Response