Computer-on-Module COM-SPEAR1340

The COM-SPEAR1340 Computer-on-Module board can serve as a building block in a wide variety of embedded applications. The computer on module board provides access to most of the peripherals available at ST SPEAR1340 system-on-chip device.

The SBC-SPEAR1340 single board computer provides an off-the-shelf complete solution for your computer based multimedia application. It brings Dual-Core Cortex A9 power with lots of peripherals in a very small Nano-ITX motherboard form factor - 120x120 mm (4.7x4.7 inch).

The COM-SPEAR1340 computer-on-module is based on the powerful dual-core ARM Cortex A9 system-on-chip processor with advanced multimedia capabilities. It has built-in high performance 2D/3D GPU, hardware video encoder and decoder and video input parallel port, with alternate configuration for 4 camera interfaces.

In addition to the standard set of peripherals (LCD, Gigabit Ethernet, PCIe 2.0, 3Gb/s Serial ATA, memory card interfaces, etc.) COM-SPEAR1340 system on module provides access to 4 camera interfaces, 2 USB 2.0 Host ports + 1 USB 2.0 OTG port (with integrated PHY) and has support for second LCD (LVDS) in some of the modifications.

The COM-SPEAR1340 computer-on-module can interface various peripherals through I2C interface. You can use USB to I2C adapters to debug the I2C interface.

Processor SPEAr1340 - Dual-core Cortex A9 HMI embedded MPU
32+32 KB L1 caches per core, with parity check
Shared 512 KB L2 cache
Accelerator coherence port (ACP)
Memory
DDR3 up to 8Gbit
NAND FLASH 16Gbit
Display LCD display controller, incl.support for Full HD, 1920 x 1080, 60 Hz, 24 bpp
Optional second display with LVDS interface
High-perf. 2D/3D GPU, up to 1080p
Hardware video decoder: multistandard up to 1080p, JPEG
Resistive touchscreen interface
Video Input Video input parallel port, with alternate configuration for 4 x camera interfaces
Hardware video encoder: H.264 up to 1080p, JPEG
Ethernet Gigabit / Fast Ethernet port (external GMII/RGMII/MII/RMII PHY)
Optional PHY assembled on the computer-on-module board
Connectivity 2 x USB 2.0 Host ports (integrated PHY)
1 x USB 2.0 OTG port (integrated PHY)
2 x I2C bus controllers, master/slave